Free photo or on-site estimate
Send a photo or book a quick visit.
Every repair runs on the same standard.
Send a photo or book a quick visit.
Itemized, no surprises.
We recommend the right one for your wall.
Loose material comes off before we recoat.
Repaired sections matched to the surrounding coat.
A quick description or photo helps.
Free, no obligation.
Itemized, no surprises.
Chip back, prep, coat, and clean up.
From settling and frost movement through Ottawa's freeze-thaw cycles.
Where the old coat lost its bond and started lifting away from the wall.
Chunks broken away, leaving pits and exposed concrete underneath.
Ottawa Parging Experts gets most repair calls after a hard winter, not during a new build. Ottawa regularly sees around 17 nights a year fall to -20°C or colder, almost all in January, and industry guides for this market cite 50 or more freeze-thaw cycles annually as the real driver of parging failure. Each cycle works water deeper into hairline cracks in the coating, then expands and contracts against the foundation until chunks let go. The zone from roughly 12 to 18 inches above grade – where snow, road salt, and splash-back moisture concentrate – is the most common failure point we see on an Ottawa wall, which gives you a specific spot to check before calling.
Road salt makes that splash zone worse than cold alone would. Salt-laden slush thrown off a driveway or sidewalk keeps water liquid at temperatures where it would otherwise sit frozen and inert, so the bottom band of a wall cycles between wet and frozen far more often than the section a foot higher up. It also stays damp longer into a thaw. That is the ordinary reason a homeowner ends up with parging crumbling at ankle height while the same coat at window-sill level still looks close to new.
Much of the Ottawa area also sits on Leda clay, a sensitive marine clay left behind when the Champlain Sea covered the region thousands of years ago. As the clay's original salt content leached out over time, its structure weakened – part of why an Ottawa foundation can move and crack in ways a foundation on more stable soil elsewhere won't. That's a real geological factor in this market, not a workmanship complaint against whoever coated your wall originally.
A repair that lasts starts with removing everything that's already failed. We chip back loose or hollow-sounding material until we hit sound, bonded concrete or block, then clean and prep the surface before any new coating goes on. Skipping this step and troweling a thin skim coat over a failing patch is the single most common reason a "repaired" section fails again within a year or two – it looks fixed for a season, then the old bond failure reasserts itself underneath the new material.
Curing is the other half of the job and the half nobody sees. A repair that dries too quickly in direct sun or a stiff wind loses its mixing water to the air before the cement has finished reacting, and it cures weaker than the same material would in shade. That shows up as fine crazing across the patch within days, or as a section that powders under a fingernail a year later. On hot, dry stretches we shade or dampen fresh work so it gains strength at the rate the mix was designed for. It is unglamorous and it is the reason two repairs made from the same bag of material can behave completely differently.
We use a polymer-modified, fibre-reinforced parging mix on repairs, chosen specifically for repeated freeze-thaw exposure rather than a plain cement mix. Where a wall visibly moves, sits in a damp low spot, or has failed more than once in the same section, we'll usually recommend a flexible acrylic parging instead, since it resists the cracking that keeps bringing homeowners back to the same repair. We confirm which one makes sense once we've seen the wall.
Repair scope varies widely – a single hairline crack from one bad winter is a different job from a wall with spalling across multiple sections. Small patch repairs typically run $300 to $600; moderate repairs covering several problem areas run $600 to $1,500; more extensive repair work runs $1,500 to $3,500. See our pricing page for the full breakdown and a project calculator, or request a free photo or on-site estimate for your specific wall.
Putting off a parging repair rarely makes the problem stay the same size. A hairline crack that lets moisture in this winter is a wider crack by spring, and a small spalled patch left through a second freeze-thaw season often spreads into the surrounding coating rather than staying contained. We're not saying that to rush anyone into a decision – a cosmetic crack that's been stable for years can genuinely wait. The distinction is whether the damage is active or dormant, and that's exactly what a free inspection tells you.
Cost is usually the practical reason to act sooner rather than later. A small patch repair in the $300 to $600 range today can turn into a moderate or extensive repair a couple of winters later if water keeps getting behind the coating. We'll always give you our honest read on urgency rather than push every job as time-sensitive – plenty of Ottawa homeowners get a free inspection, hear that their crack is cosmetic and stable, and don't book anything further until it changes.
You can do a rough version of our first inspection step yourself, and it costs nothing. Take the handle of a screwdriver or a small hammer and tap lightly along the wall, working from the top of the parging down to grade. Well-bonded parging gives back a tight, solid sound. Anywhere the coat has released from the concrete or block behind it gives back a hollow, drummy note instead.
That hollow area is almost always larger than the visible crack that made you look in the first place. Mapping it with a few minutes of tapping tells you more about the real scope of the work than any photograph will. If the drummy sound is confined to a patch you could cover with one hand, you are likely in patch-repair territory. If it runs along most of the bottom band of the wall, the crack you noticed is a symptom rather than the problem, and any quote that prices only the crack is pricing the wrong thing.
Two details are worth noting while you tap. Check whether the hollow zones line up with a downspout outlet, a walkway that drains back toward the house, or a low corner that holds snow late into spring, because a coat that keeps failing in the same place usually has a water source feeding it. Then check the same wall again after the next thaw. A hollow zone that has spread is active and worth dealing with in the coming season. One that has not moved in two years can reasonably wait until the timing and the budget suit you, and we will tell you so.
If failure is limited to a few sections and the rest of the coat is sound, a repair usually makes sense. When most of the wall is cracked, flaking, or spalled, a full recoat is the more durable option – we'll tell you which one applies after inspecting the wall.
A properly prepped repair should perform as long as the surrounding coat, roughly 10 to 25 years, depending on moisture exposure and freeze-thaw cycling.
Yes – we blend texture and, where possible, colour so the repair doesn't stand out as an obvious patch.
Parging needs above-freezing temperatures to cure properly, so repairs run spring through fall. Winter is for quotes and scheduling.
Repeated freeze-thaw cycling, water sitting against the wall, and poor original surface prep are the most common causes we see on Ottawa homes.